#GX WORKS 2 CC LINK SETUP HOW TO#
#GX WORKS 2 CC LINK SETUP 64 BITS#
#GX WORKS 2 CC LINK SETUP SOFTWARE#

Getting Data From an In-Sight Vision System For more information, see CC-Link IEВ Field Network Basic Factory Interface. Note: The CC-Link IEВ Field Basic Interface topic contains detailed information about mapping the In-Sight vision system's inputs and outputs into process memory, though the layout of the blocks depends on the version of In-Sight firmware running on the In-Sight vision system.

An In-Sight vision system can be triggered by directly manipulating the Trigger Enable and Trigger bits in the RY Block, or by monitoring the Trigger Ready, Trigger Ack and Missed Acq bits in the RX Bit Block.

For more information, see Online/Offline.

Place the In-Sight vision system Online.

Set the Trigger parameter to Industrial Ethernet.

Open the AcquireImage function's property sheet.

After restarting the PLC, it will begin scanning the vision system over CC-Link IEF Basic.Д¬onfiguring the In-Sight Vision System to Receive Image Acquisition Triggers.

Accept all parameter dialogs and downloads the project to the PLC.

Select the PLC memory used to store the synchronized CC-Link IEF Basic registers.

Add the vision system to the link scan list, and selects the desired number of stations (1-16) to scan on the vision system.

Click on the Network Configuration Setting button to open the CC-Link IEF Basic Configuration dialog.

Check the Use the CC-Link IEF Basic checkbox.

Click on the Built-in Ethernet Port Setting tab and presses the CC-Link IEF Basic Setting button.

#GX WORKS 2 CC LINK SETUP SOFTWARE#

Open the Mitsubishi GXВ Works 2 software to connect their PLCВ to the In-Sight vision system.

Restart the In-Sight vision system, and the CC Link IEВ Field Basic protocol will be enabled upon completion of the power cycle.

In the Industrial Ethernet Protocols section of the dialog, select CC-Link IEВ Field Basic.

From the Sensor menu, open the Network Settings dialog.Open In-Sight Explorer and connect to the desired In-Sight vision system.For more information on CC-Link IEВ Field Basic, refer to Mitsubishi's CC-Link IE Field Network Basic Reference Manual.To enable CC-Link IEВ Filed Basic from the EasyBuilder View, refer to the EasyBuilder Help (Communication > Device Setup > Communicating with Mitsubishi Devices > CC-Link IEВ Field Basic).

#GX WORKS 2 CC LINK SETUP HOW TO#

This section describes how to connect to an In-Sight vision system using CC-Link communications to a Mitsubishi Q-Series Automation Controller. Configuring In-Sight Vision Systems for CC-LinkВ Protocol Communications Once the protocol is enabled and the vision system is configured in the controller, the controller will begin cyclic communications to the In-Sight vision system through a request/response mechanism. The data is mapped into controller memory through the Mitsubishi setup tools (GXWorks 2/3).

#GX WORKS 2 CC LINK SETUP 64 BITS#

The communications support 64 bits and 32 16-bit words of data per station in each direction, with each slave supporting 4 stations.

As opposed to the existing SLMP (MC Protocol), the Mitsubishi automation controllers act as the master, driving the communications to the slave devices over standard UDP messaging.

Communicating with a Mitsubishi Automation Controller on CC-Link IEВ Field Network BasicД¬C-Link IE Field Basic is a protocol designed to integrate Ethernet devices into a Mitsubishi Automation Controller.

Gx works 2 cc-link setup